Mocomtech CIM-550 - Manual (Page 100)

CiM-550 IP Enabled Satellite Modem Rev. 2
Remote Control CD/CIM550.IOM
74
Parameter
Type Command
(Instruction
Code and
qualifier)
Arguments for
Command or
Response to
Query
Description of arguments
(note that all arguments are ASCII numeric
codes, that is, ASCII codes between 48 and 57)
Response to Command
(target to controller)
Query
(Instruction
Code and
qualifier)
Response to
query
(target to
controller)
127 starting at address location 104.
(Used for power-level cal, amongst other things)
Read
EEPROM
Value N/A 3 bytes Query only. FACTORY USE ONLY
A query in the form aaa where aaa is a starting bit
address (in the range 0 - 127) within the modem’s
serial EEPROM, requesting that the byte stored at
that location be returned. Example: ERD?063
returns the value of the byte stored at location 063.
(Used for power-level cal, amongst other things)
N/A ERD? ERD=xxx
where xxx is a
value between 0
and 255
Set RTC
Date DAY= 6 bytes,
numerical
Command or query
A command in the form ddmmyy, where; dd = day
of the month, between 01 and 31, mm = month of
the year, between 01 and 12 and yy = year,
between 97 and 96 (1997 to 2000, then 2000 to
2096)
Example: DAY=240457 would be April 24, 2057
DAY= (message ok)
DAY? (received ok,
but invalid arguments found)
DAY* (message ok, but not
permitted in current mode) DAY? DAY=xxxxxx
(same format
as command
arguments)
Set RTC
Time TIM= 6 bytes,
numerical
Command or query
A command in the form hhmmss, indicating the
time from midnight, where hh = hours, between 00
and 23; mm = minutes, between 00 and 59, and ss
= seconds, between 00 and 59
Example: TIM=231259 would be 23 hours, 12
minutes and 59 seconds from midnight.
TIM= (message ok)
TIM? (received ok,
but invalid arguments found)
TIM* (message ok, but not
permitted in current mode)
TIM? TIM=xxxxxx
(same format
as command
arguments)
Clear All
Stored
Events
CAE= None Command only
Instructs the unit to clear all Stored Events
This command takes no arguments.
CAE= (message ok) N/A N/A
Set
Statistics
Sample
Interval
SSI= 1 byte,
numerical
Command or Query.
Used to set the sample interval for the Statistics
Logging Function.
SSI= (message ok)
SSI? (received ok,
but invalid arguments found) SSI? SSI=x (see
description for
details of
argument)