MITSUBISHI ELECTRIC DX-TL5716U - Manual (Page 119)

115
Others
Step
3 Select [Next] next to [E-mail notifi cation - Details]
to check the contents of the e-mail sent to the
PC.
[Remain]: Notified when a remaining capacity
warning (call-out setting) is issued.
[Temp/Fan]: Notified when a high temperature is
detected or the fan stops.
[Reboot]: Notified when an error occurs in the
recorder.
[REC]: Notifi ed when recording starts.
[Alarm REC]: Notifi ed when alarm recording starts.
[Sensor]: Notified when a signal is input to the
terminal on the rear panel.
[No signal]: Notified when video signal from the
camera is lost.
[Attach image]: Notified when the e-mail image
attachment function is used.
Notice
• To change the contents of e-mail, use the Web
function of the recorder.
IP alarm notifi cation - Address setting
Step
1 Select [Confirm] next to [IP alarm settings] on
the <LAN setting> screen.
• The <IP alarm notifi cation - Address setting> screen
is displayed.
Step
2 Check the settings of [IP address] and [COM
port].
• These settings are for notifying the connected PC of
issuance of warning and variation in the status such
as when the rear terminal is short-circuited.
• When you select [Test], test e-mail is sent to the
selected IP address and communication port.
Notice
• To change the IP addresses and communication ports,
use the special PC viewing/communication software.
For the usage, refer to the instruction manual of the
software.
• No notifi cation is sent to the broadcast address.
Step
3 Select [Next] next to [IP alarm notification -
Details] to check the contents of the e-mail sent
to the PC.
[Remain]: Notified when a remaining capacity
warning (call-out setting) is issued.
[Temp/Fan]: Notified when a high temperature is
detected or the fan stops.
[Reboot]: Notified when an error occurs in the
recorder.
[REC]: Notifi ed when recording starts.
[Alarm REC]: Notifi ed when alarm recording starts.
[Sensor]: Notified when a signal is input to the
terminal on the rear panel.
[No signal]: Notified when video signal from the
camera is lost.
Notice
• To change the contents of e-mail, use the special PC
viewing/communication software. For the usage, refer
to the instruction manual of the software.
FTP transmission settings
Step
1 Select [Confirm] next to [FTP transmission
settings] on the <LAN setting> screen.
• You can check the settings of FTP notifi cation.
Notice
• To change the FTP notification settings, use the
special PC viewing/communication software. For the
usage, refer to the instruction manual of the software.
Tips
• Ports used by the recorder's communication
functions.
You can check the available ports of this recorder on
the <LAN service port settings> screen.
To confi gure the IP masquerade of a BB router or other
device for connection with the special PC viewing/
communication software, set the following items.
• Web port
• SSL port
• Special communication software port
• RTP receiving port