MITSUBISHI ELECTRIC DX-TL5716U - Manual (Page 61)

57
Recording
Notice
• When the total FPS of all the recordings being
performed is around the following values, they may not
be performed according to the specifi ed settings.
When the total FPS is around the following values, you
cannot view images from the inactive cameras via the
network.
When the picture size is set to [4CIF] ........120 FPS
When the picture size is set to [2CIF] ........240 FPS
When the picture size is set to [CIF] ..........480 FPS
Tips
• <Estimated time>
• [Estimated time] is displayed at the bottom of the
screen, which shows the maximum continuous
recording time at the picture quality and FPS for
normal recording.
• When you change the capacity of the normal
recording area in the partition setting, the estimated
time is displayed according to the specifi ed capacity.
• The estimated time is just for a guide. Depending
on the recorded images, the actual recording time
may vary considerably. As more motion images are
recorded, the actual recording time may become
shorter than the estimated time.
• When the sum of each FPS is around the following
values, [Total FPS] is displayed in red and an error
message appears. In this case, decrease the FPS.
When the picture size is set to [4CIF] ........120 FPS
When the picture size is set to [2CIF] ........240 FPS
When the picture size is set to [CIF] ..........480 FPS
• [Total FPS] shows the sum of the larger values
between the FPS for normal recording and that for
alarm recording of the selected cameras. (The value
displayed in [Total FPS] is not same as the sum of the
displayed FPS.)
Alarm camera setting
Step
10 Select recording cameras for each connected
sensor.
• Alarm recording is performed with selected cameras.
• When an alarm signal is input during normal
recording, images from cameras selected for alarm
recording are recorded at the alarm recording
FPS rate while images from the other cameras are
recorded at the normal recording FPS rate. The
maximum total of the alarm recording FPS and
normal recording FPS of the selected cameras is as
follows.
When the picture size is set to [4CIF] ...... 120 FPS
When the picture size is set to [2CIF] .......240 FPS
When the picture size is set to [CIF] .........480 FPS
Alarm input to 3ch
Alarm input to 5ch
1ch
2ch
3ch
4ch
5ch
6ch
Alarm recording
Alarm recording
Nomal recording
Nomal recording
Nomal recording
Nomal recording
Nomal recording
Nomal recording
Nomal recording
Nomal recording
• When the setting is completed, select [Next]. The
<Alarm input/output> screen is displayed.
Tips
• You can select multiple cameras per sensor input.