Sharp MD-MT90 - Manual (Page 13)

00/12/26 90SEC_12_15.fm
13
Ba
si
c O
p
er
at
ion
-Rec
or
ding-
To interrupt recording
Press the PLAY/PAUSE button.
z To resume recording, press the PLAY/PAUSE button
again.
z The track number will be increased by one each time
the recording is interrupted.
To stop recording
Press the /:OFF button.
z When recording stops, "TOC" appears. While "TOC"
appears, the MiniDisc recorded contents have not yet
been updated.
z To prevent the new recording from being lost, it is not
possible to remove the MiniDisc while "TOC" is dis-
played.
To update the recorded contents of the
MiniDisc
Press the /:OFF button while in the stop mode.
The power turns off after recorded contents have been
updated on the MiniDisc.
About the TOC
After any recording or editing function, "TOC" (Table Of
Contents) is displayed. To finalise the recording or editing
function, press the /:OFF button. During this process,
"TOC" will flash and "TOC EDIT!" will be displayed. Dur-
ing any recording or editing function, the MiniDisc unit lid
is locked, and the MiniDisc cannot be removed until the
process is finalised.
Warning:
If the power is removed (Battery/AC adaptor) while "TOC"
is displayed, the MiniDisc unit lid will remain locked until
the battery/main power is restored and the unit is turned
on. Your new recordings or edited changes will be lost
and your MiniDisc may become unusable.
Caution:
While "TOC" or "TOC EDIT!" is displayed, follow the
instructions below.
Otherwise, tracks may not be recorded properly.
Notes:
z Changing the volume level while recording does not
affect the recording.
z You cannot adjust the bass level while recording.
5
Press the PLAY/PAUSE button to start the
MiniDisc unit recording.
6
Begin playback on the stereo system, and
the output will be recorded.
- Do not jerk or bump the unit.
- Do not unplug the AC adaptor.
- Do not remove the rechargeable battery or an alka-
line battery.
- Do not subject the unit to shock.