Sharp MD-MT90 - Manual (Page 24)

00/12/26 90SEC_16_30.fm
24
U
s
efu
l Fe
at
ur
es
-Recor
d
ing
f
rom a M
icr
o
phone-
Recording from a Microphone (continued)
„ Sound-actuated recording (Mic Syn-
chronized recording) About the pause function
The unit automatically pauses when the microphone
does not pick up any sound for 3 seconds or more.
(The pause function does not work for approximately 10
seconds after a recording starts.) When the microphone
picks up sound again, recording starts automatically.
Notes:
z While making a mic recording, do not connect any-
thing to the OPTICAL/LINE IN jack on the portable
MD.
z To use a microphone, be sure it is a plug-in-power
type microphone.
z Insert the plug firmly. If you don't, the recording will not
be made properly.
z Use a microphone with a 1/8" (3.5 mm) diameter
stereo mini plug.
z If the unit starts recording too often from low unwanted
noises, set the microphone input to "MIC SYNC L".
z Recording sensitivity can be changed while recording.
1
Press the REC button.
2
Press the or button to adjust the re-
cording level.
3
Press the ENTER/SYNC button to select
the recording sensitivity.
MIC SYNC H : Recording starts when the unit
detects --- 24 dB or more (The unit
can start recording from quiet
sounds).
MIC SYNC L : Recording starts when the unit
detects --- 12 dB or more.
4
When a sound, such as person speaking,
is picked up by the microphone, recording
will begin automatically.
- When a plug-in-power type microphone is plugged in,
the portable MD will provide power for the microphone's
operation.
- If a different type of microphone is plugged in, it may not
operate properly or it may cause the unit to malfunction.