Sanyo PLC-WXE46 - Manual (Page 27)

PLC-WXE46/WXL46 Expand Serial Command Functional Specifications
27/65
8.7.3 CF_KEYSTONE Command
Command “CF_KEYSTONE_%1”[CR]
%1
“UP” ------------- Correct Keystone distortion to reduce upper part of image
“FUP” ----------- Correct Keystone distortion to reduce upper part by 2steps
“DN” ------------- Correct Keystone distortion to reduce lower part of image
“FDN” ----------- Correct Keystone distortion to reduce lower part by 2steps
“RST” ------------ Set Keystone OFF
Details
Change Keystone distortion correction
This command is available in normal Power ON status.
Response
Acceptable “000”[CR]
Unacceptable
“Error Code”[CR]
“201”[CR] ----When reaching the Keystone correction limit or
reaching 1 step to correction limit and “FDN”/”FUP”
is received.
(The command is not executed)
8.7.4 CF_KYSTNMODE Command
Command “CF_KYSTNMODE_%1”[CR]
%1
“STR” --------- Set Keystone store mode to Store
“RST” --------- Set Keystone store mode to Reset
Details
Set Keystone store mode
This command is available in normal Power ON status.
Response
Acceptable “000”[CR]
Unacceptable “Error Code”[CR]
8.7.5 CF_VSCALE Command
Command “CF_VSCALE_%1”[CR]
%1
“032” --------- +32
“031” --------- +31
“002” --------- +2
“001” --------- +1
“000” --------- +0
“-01” ---------- -1
“-02” ---------- -2
“-31” ---------- -31
“-32” ---------- -32
“UP” ---------- Vertical Scale setting value + 1
“DN” ---------- Vertical Scale setting value - 1
Details
Set Vertical Scale
This command is available in normal Power ON status.
Note1) When Screen setting is not Custom, projector returns 101[CR] and the
command does not excute.
Note2) When there is no Input, projector returns 101 and the command does not
excute.
Response
Acceptable “000”[CR]
Unacceptable “Error Code”[CR]