Sony PDW-V1 - Manual (Page 27)

C
h
ap
te
r 2
N
a
m
e
s
a
n
d
F
u
nc
ti
on
s
of
P
a
rt
s
27
2-4 Connectors
2-4 Connectors
For the locations of the AC power inlet connector on the
left side of the PDW-V1, and the AC power switch on the
rear panel, see the figure on page 19.
a PHONES jack and LEVEL knob
The jack is a standard stereo jack. Connect stereo
headphones with an impedance of 8 ohms, to monitor the
audio during playback. The channels monitored are
selected by the AUDIO MONITOR buttons.
Non-audio signals are muted.
Adjust the volume with the LEVEL knob. You can also set
this to simultaneously control the output volume from the
AUDIO MONITOR OUT L/R connectors on the side
panel. To do this, in the setup menu, set extended menu
item 114 “AUDIO MONITOR OUTPUT LEVEL” to
“var.”
b (network) connector (RJ-45, 100Base-TX)
To transfer files between an external device and the PDW-
V1, connect a network cable to this connector and the
external device.
Note
For safety, when connecting external devices to this
connector, do not connect connectors which may have
excessive voltage. Follow the instructions in this manual
when making connections.
c S400 (i.LINK) connector (6-pin, complying with
IEEE1394)
Using the AV/C protocol: Outputs a DVCAM format
digital video/audio signal.
Using FAM protocol: Transfers files to and from
supporting devices.
Notes
• If video or audio signals from an external device
connected with the S400 (i.LINK) connector are not
output, disconnect the i.LINK cable and connect it again,
pushing it straight in.
• When the PDW-V1 is connected to a device with a 6-pin
i.LINK connector by an i.LINK cable, before
unplugging the i.LINK cable, first power off the device
and disconnect the power plug from the outlet. If the
i.LINK cable is unplugged with the device power plug
still connected, a current from an excessive voltage (8 to
40 V) output from the i.LINK connector of the device
flows into the PDW-V1. This may cause a failure of the
PDW-V1.
• When connecting the PDW-V1 to a device with a 6-pin
i.LINK connector, connect to the 6-pin i.LINK
connector of the other device first.
• Except in playback mode (jog and shuttle modes, etc.), if
you are monitoring the audio signal output from this
connector on another device, the audio signal may sound
differently from the audio signal played back on the
PDW-V1.
d MONITOR connector (D-sub 15-pin)
Outputs analog RGB signals. Wnen connecting a PC-
compatible display or projector to this connector, set it for
VGA
1)
input.
1) VGA is a registered trademark of International Business Machines
Corporation.
LEVEL PHONES
VIDEO OUT
MONITOR
SDI OUT AUDIO MONITOR OUT
L R
S400
1 PHONES jack and LEVEL knob
2 (network) connector
3 S400 (i.LINK) connector
4 MONITOR connector
5 VIDEO OUT connector
6 AUDIO MONITOR OUT L/R connectors
7 SDI OUT connector
Front Right side