PIONEERPOS AT Commands G24-LC - Manual (Page 414)

AT Commands Alphabetical Summary
A-12 G24-L AT Commands Reference Manual April 15, 2008
+MIPCALL This command creates a wireless
PPP connection with the GGSN,
and returns a valid dynamic IP
for the G24-L. Page 3-276
+MIPCFF This command sets the Filtering
List. Page 3-301
+MIPCLOSE This command causes the G24-L
to free the socket accumulating
buffer and disconnect the G24-L
from a remote side. Page 3-282
+MIPCONF Configure Internal TCP/IP stack. Page 3-289
+MIPFLUSH This command causes the G24-L
to flush (delete) data accumulated
in its accumulating buffers. Page 3-286
+MIPODM This command causes the G24-L
to initialize a new socket in
Online Data Mode and open a
connection with a remote side. Page 3-279
+MIPOPEN This command causes the G24-L
to initialize a new socket and
open a connection with a remote
side. Page 3-277
+MIPPUSH This command causes the G24-L
to push the data accumulated in
its accumulating buffers into the
protocol stack. Page 3-285
+MIPRTCP This unsolicited event is sent to
the terminal when data is
received from the TCP protocol
stack. Page 3-287
+MIPRUDP This unsolicited event is sent to
the terminal when data is
received from the UDP protocol
stack. Page 3-287
+MIPSEND This command causes the G24-L
to transmit the data that the
terminal provides, using an
existing protocol stack. Page 3-284
+MIPSETS This command causes the G24-L
to set a watermark in the
accumulating buffer. When the
watermark is reached, data is
pushed from the accumulating
buffer into the protocol stack. Page 3-283
Table A-1: AT Commands (Alphabetical) (Cont.)
AT Command Description Page