Numark Industries TT500 User Manual

Page 11

Advertising
background image

TONE ARM SETUP

A properly adjusted tone arm and cartridge setup will minimize vinyl record wear and optimize the
performance of the turntable. Follow these simple steps for setting the tone arm on the turntable:


NOTE: In most cases, when using the S-Shaped tonearm tube, the additional S-Weight must be fastened to

the tonearm to achieve proper stylus pressure.Balancing the Tone Arm

1. Begin the balancing process by lifting the cue lever to the up position (or make sure that the stylus protector
is on the cartridge.)


2. Next, rotate the counterweight clockwise until it is in the complete forward position (NOTE: this is also the

maximum amount of pressure that can be applied to the cartridge.)

3. Now there should be a feeling of weight and resistance when the head shell is raised and lowered. Begin
rotating the counterweight counter-clockwise (away from the pivot point) until this weight and resistance
feeling is gone. If done properly, the tone arm will pivot with very little resistance back and forth indicating

that there is exactly 0 grams of stylus pressure.

4. With the counterweight in its new position further away from tone arm pivot point, grasp the scale ring of
the counter weight and rotate it until "0" is in the vertical position.


5. Finally, rotate the counterweight (and scale ring) clockwise (towards the pivot point) until the desired

amount of weight is reached. If the scale rotates 360 degrees beyond the zero point, the new scale ring
reading should be added to 3.5.


*The included head shell and cartridge assembly requires a minimum of 3 grams and no more than 5 grams

for optimum performance.

Setting the Anti-Skate Adjustment

In most cases, the Anti-Skate should be set to its minimum setting. Anti-Skate compensates for inward

tracking forces that occur with certain cartridges when the stylus nears the center of the record. If the
turntable is experiencing excessive skipping during back-cueing and scratching while nearing the center

spindle, try increasing the Anti-Skate in the increments indicated on the dial. Start by adding an increment of
1, test its performance, than increase it more, and so on.




1.

2.

3.

+

-

=

=

4.

0

3

2.5

2

1.5

1

0.5

Only Rotate

Scale Ring!

5.

0

3

2.5

2

1.5

1

0.5

0

3

2.5

2

1.5

1

0.5

+

360

o

4.5 grams =

MIN

MAX

PAGE 10

TONE ARM SETUP

Advertising