Numark Industries TT500 User Manual
Page 12
CARTRIDGE SETUP
For Head Shell Mounted Cartridges:
The cartridge that comes with this turntable should be preinstalled on the head shell. If it isn't, please follow
the below instructions for installing a cartridge onto the head shell.
1. Position the head shell and the cartridge so that the four connector pins are visible. Make sure that the
stylus cover is installed to prevent damage to the stylus during installation.
2. Prepare to connect the cartridge to the head shell using the green, red, blue and white connector wires.
3. Starting with the upper left pin and going clockwise install the white, the red, the green and finally the blue
wires to the connector pins. Be careful not to bend the metal clips on the end of the wires. These metal
connectors should never make contact with one another.
4. Using the screws and bolts that are included with the cartridge, loosely fasten the cartridge to the head shell
body.
5. Once temporarily fastened, position the cartridge so that both screws are aligned with the optimum position
mark on the Head shell (Numark HS 1 Head shell and Numark Cartridges only.) Moving the both screws to a
mark away from the optimum position indicated on the head shell may increase or decrease performance
depending on the cartridge used. For safe vinyl record treatment, the screws should always be aligned
perpendicular to the head shell (any angle may increase "record burn.")
6. Once the cartridge is positioned correctly, secure the cartridge to the head shell by tightening the mounting
screws.
For Integrated Head Shell Cartridges (Numark CS-1, CC-1, CX-1, etc.)
7. Align the pin on the rear of the Cartridge Assembly so that it is in a vertical position and insert it into the
tone arm lock nut.
8. Secure the cartridge to the tone arm by turning the tone arm lock nut clockwise until the head shell feels
secure and does not wobble to the left or right. WARNING: Over tightening the tone arm lock nut may result in
permanent damage to the tone arm or the cartridge.
9. Remove the stylus protector before playback.
1.
Cartridge
Headshell
Connector
Pins
2.
Cartridge
Headshell
W
R
G
B
3.
Red
Green
White
Blue
4.
DO NOT TIGHTEN!
5.
ALIGNED
6.
7.
8.
DO NOT OVERTIGHTEN!
PAGE 11
CARTRIDGE SETUP