Numark Industries TT500 - Manual (Page 5)

CONTROLS
General Controls
1. Power Button
This button turns on the turntable when pressed. It illuminates blue when the turntable is switched on.
2. Platter
This turntable has a special edge design that has been optimized for "dragged" platter slow downs. (NOTE: The pattern
will appear to stand still when the Pitch Range is set to 0% and the Target Light is being used.)
3. Start/Stop Buttons
These buttons start and stop the turntable motor. Both buttons have the same function.
4. Reverse Button
Pushing this button down will reverse the rotation direction of the turntable platter.
5. Strobe Target Light and Power Jack
This aluminum light can be rotated depending on the head shell position and the amount of light required on the vinyl
record surface. The light also strobes against the platter edge making the pattern appear to stand still when the Pitch
Range is at 0%.
6. 33 and 45 RPM Buttons
These buttons control the RPM of the turntable platter. When both of the 33 and 45 RPM buttons are pressed, the 78 RPM
mode will engage.
7. Start Time Adjuster
This control can be rotated to increase or decrease the startup time of the motor.
8. Braking Time Adjuster
This control can be rotated to increase or decrease the stopping time of the motor.
1
9
11 10 6 5 7
2 8
3 4
CONTROLS PAGE 4