NEC Disk Array Controller N8103-89 - Manual (Page 79)

59
1 Channel 1 - 4 (Port 1 - 4)
These channels allow the card to be connected to SATA devices.
Channel 2 Channel 4
Channel 3 Channel 1
2 HW label
Indicates the management revision of the card.
REV
XXX
3 Additional battery connector
The connector allows the card to be connected to an additional battery.
4 I2C connector
The connector is connected with an I2C cable.
5 N code label
Indicates the N code of the card.
N8103-89
6 HDD LED connector
The connector allows the card to be connected to the motherboard in the server in order
to illuminate the DISC ACCESS lamp on the server.
7 PCI connector
The connector allows the card to be connected to a PCI slot in the server.