National Instruments cFP-20xx - Manual (Page 6)

cFP-20xx Quick Start Guide 6 ni.com
2. Bolt or screw the panel-mount accessory to a panel.
3. Connect the PE ground terminal on the cFP-BP-x to safety ground.
Caution Disconnect power before removing the backplane from the
panel.
Mounting the Backplane on a DIN Rail
NI recommends DIN rail mounting for the cFP-BP-4 only. Use panel mounting
or rack mounting for the cFP-BP-8. The DIN rail mounting kit is NI part
number 778614-01.
1. Fasten the DIN rail clip to the cFP-BP-4 using a number 2 Phillips screwdriver
and the 8-32 × 5/16 in. countersink screws shipped with the clip.
104.74 mm
(4.1 in.)
63.46 mm
(2.5 in.)
127.00 mm
(5.0 in.)
22.19 mm
(0.9 in.)
34.04 mm
(1.3 in.)
84.84 mm
(3.3 in.)
161.04 mm
(6.3 in.)
211.84 mm
(8.3 in.)
245.87 mm
(9.6 in.)