RAD Data comm E1 Interface Converter RIC-E1 - Manual (Page 40)

Chapter 5 RIC-E1/R Card RIC-E1 Installation and Operation Manual
5-8 Installing the RIC-E1/R Card
4. When operating RIC-E1/R with unbalanced interface, use CIA/TB-BNC/214
adapter, which converts the terminal block connector into two coaxial BNC
connectors.
5. If required, attach the appropriate CIA (CIA/X.21/1, CIA/V.35/1, CIA/ETH) or
CBL-530/449F adapter cable to the DB-25 connector on the card cage rear
panel.
6. Connect the DTE cable to the DB-25 connector, other side of CIA or adapter
cable (depending on your version of the card interface).
7. Connect power to the ASM-MN-214 card cage:
To connect AC power, connect the power cable to the mains supply.
To connect DC power, refer to DC power supply connection supplement
of the ASM-MN-214 installation and operation manual.
The ASM-MN-214 card cage has no power switch. Operation starts when the
power is applied to the rear panel POWER connector. When applying power,
first connect the plug of the power cord to the ASM-MN-214 POWER
connector and then to the mains (outlet).
Warning
Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com