RAD Data comm ASMi-52 - Manual (Page 101)

Installation and Operation Manual Chapter 5 Configuring a Typical Application
ASMi-52 Ver. 2.5 Configuring the ASMi-52 units 5-3
Set the CO ASMi-52 unit clock to Internal.
Set the CPE ASMi-52 unit clock to Receive.
3. Select Save to save the changes.
To set the device host IP address:
1. Display the host IP menu (Main menu > Configuration > System
Configuration > Management > Host IP.
The host IP screen appears.
2. From the host IP menu, configure the following:
ASMi-52 IP address – 172.17.161.73
Host IP mask – 255.255.255.0
Host default gateway IP address – 172.17.161.1
ASMi-52
Host IP address (172.17.161.730)
Host IP mask (255.255.255.01)
Host default gateway (172.17.161.1)
Read community (public)
Write community (public)
Trap community (public)
>
ESC-prev. menu; !-main menu; &-exit; @-scroll
Figure 5-3. Host IP Menu
3. Press ESC to return to previous menu (Management menu).
4. Save the changes.
Setting the E1 Port
To select E1 framing mode:
1. Display the Framed Mode menu (Main menu > Configuration > E1
Configuration > E1 Local Port menu > Framed Mode).
The Framed Mode menu appears.
ASMi-52
Framed mode (Unframed)
1. Unframed
2. G732N
3. G732S transparent
>
ESC-prev. menu; !-main menu; &-exit; @-scroll
Figure 5-4. Frame Mode (Unframed) Menu