RAD Data comm ASMi-52 - Manual (Page 40)

Chapter 3 Operation Installation and Operation Manual
3-4 Default Settings ASMi-52 Ver. 2.5
3.3 Default Settings
ASMi-52 is managed by an ASCII terminal or a PC running a terminal emulation
program via a menu-driven embedded software.
Table 3-4 lists the default settings
of the ASMi-52 configuration parameters.
Table 3-4. Default Settings
Parameter Default Value
System
Clock Internal
Sys contact –
Sys location –
Sys name –
Host IP address 0.0.0.0
Host IP mask 0.0.0.0
Host default gateway 0.0.0.0
Read community public
Write community public
Trap community public
SNMP allowed Access allowed
Telnet allowed Access allowed
WEB allowed Access allowed
DTS IP address 0.0.0.0
DTS IP mask 0.0.0.0
LAN Configuration
LAN operation mode Transparent
Encapsulation CRC No
Bridging Mode Access only
Aging Timeout 10
Autonegotiation Enable
LAN Rate 1. Single 2-wire – 192 kbps
4-wire – 384 kbps
2. E1+LAN N/A (0 kbps)
3. Serial DTE+LAN N/A (0 kbps)
Max AutoNeg Capability 100BaseT full duplex mode