TANDBERG D12155-10 - Manual (Page 95)

TANDBERG Videoconferencing System
95
Peripherals
5 Video Inputs
• 2 video inputs supporting S-Video through Mini-DIN connectors.
• 2 video inputs supporting composite signals through RCA connectors.
• 1 VGA input supporting resolutions VGA(640x480), SVGA(800X600) and XGA*(1024x768) (auto sensing).
The standard camera uses one of the S-Video inputs. The system will automatically adapt to a PAL or NTSC
input.
5 Video Outputs
• 2 S-Video outputs, Mini-DIN connectors.
• 2 composite video outputs, RCA connectors.
• 1 VGA output supporting resolutions VGA(640x480), SVGA(800X600) and XGA*(1024x768).
The first Mini-DIN connector and the first RCA connector provide main video (incoming/outgoing video and menus).
The two other connectors provide selfview/still image/Duo Video. The S-Video outputs are used by default by the
monitors. The outputs are always active.
The format of the output will be either PAL or NTSC depending on your country’s standard video format.
4 Audio Inputs
• 2 microphone inputs (balanced, 24V phantom powered) via XLR connectors.
• 2 audio inputs (line level) via RCA connectors.
All audio inputs are active by default. For further information, refer to section ‘Audio Settings’.
3 Audio Outputs
• 1 output (line level) via RCA connector providing audio from far end in addition to dial tones. This output is used
either by the monitor or by the Natural Audio module (if installed).
• 1 AUX output (line level) via RCA connector providing a mixed signal between audio from the local side (except
from the AUX input) and audio from the far end. This output is intended for connection to a telephone add-on
system.
• 1 VCR output (line level) via RCA connector providing a mixed signal between audio from the local side (except
from the VCR input) and audio from the far end. This output is intended for connection to a VCR.
* E2 only