21 set pvc command, 22 set pvcs command, 23 show pvc command – ZyXEL Communications AES-100 User Manual
Page 43
AES-100 User’s Guide
ADSL Configuration
5-11
5.5.21 Set PVC Command
Syntax:
192.168.1.1 adsl> set pvc <port number> <multiplexing mode> <tx vpi> <tx vci> [<rx
vpi> <rx vci>]
where
<port number> =
port number, from 1 to 8.
<multiplexing mode> =
either “llc” or “vc"
<tx vpi> =
the VPI setting of the ADSL port for use with a TX based network
<tx vci> =
the VCI setting for the ADSL port for use with a TX based network
<rx vpi> =
the VPI setting for the ADSL port for use with Rx based networks
<rx vci> =
the VCI setting for the ADSL port for use with Rx based networks
The
<rx vpi>
and
<rx vci>
settings
will be equal to those of
<tx vpi>
and
<tx vci>
if the rx settings
are not configured.
The
set pvc
command allows the configuration of a PVC (permanent virtual circuit) for an individual ADSL
port.
5.5.22 Set PVCs Command
Syntax:
192.168.1.1 adsl> set pvcs <multiplexing mode> <tx vpi> <tx vci> [<rx vpi> <rx
vci>]
where
<multiplexing mode> =
either “llc” or “vc”
<tx vpi> =
the VPI setting of the ADSL ports for use with a TX based network
<tx vci> =
the VCI setting for the ADSL ports for use with a TX based network
<rx vpi> =
the VPI setting for the ADSL ports for use with Rx based networks
<rx vpi> =
the VCI setting for the ADSL ports for use with Rx based networks
The
<rx vpi>
and
<rx vci>
settings
will be equal to those of
<tx vpi>
and
<tx vci>
if the rx settings
are not configured.
The
set pvcs
command allows you to configure a single PVC for all of the ADSL ports at once.
5.5.23 Show PVC Command
Syntax:
192.168.1.1 adsl> show pvc <port number>
where
<port number> =
port number, from 1 to 8.
The show pvc command allows you to display the PVC parameters of an individual ADSL port.