ZyXEL Communications Omni TA128 - Manual (Page 145)

133
S-Register Descriptions
The descriptions for each S-register. In most bit-mapped S-
registers, the default bit value is 0 (which is the normal situation)
and only the non-default situation is described. Some reserved bits
are for factory use and the user should not change them.
Values followed by an asterisk * are the factory default settings.
Basic S-Registers "ATSn=x"
Command Function & Description Ref.
S0= Set the number of rings on which the TA will
answer. A 0 value disables auto-answer. +000
S1= Counts and stores number of rings from an
incoming call. +000
S2= Define escape code character, default <+> (43
dec.). +043
S3= Define ASCII Carriage Return. +013
S4= Define ASCII Line Feed. +010
S5= Define ASCII Backspace. +008
S7= Set duration, in number of seconds, TA waits
for a carrier. +060
S8= Set duration, in seconds, for pause (,) option
in Dial command and pause between
command re-executions for Repeat
(>)command. +002
Extended S-Registers "ATSn=x"
Command bit dec hex Function and description Ref.
S15= bit dec hex Bit-mapped register. +130
0,1 0 0 Even parity.
1 1 Odd parity.
2 2 * No parity.
2 0 0 * 1 stop bit.
4 4 2 stop bits.