Static route screens, 1 static route overview, 2 ip static route screen – ZyXEL Communications NBG334W User Manual
Page 155: Chapter 15 static route screens, Figure 84 example of static routing topology, Static route screens (155)
NBG334W User’s Guide
155
C
H A P T E R
15
Static Route Screens
This chapter shows you how to configure static routes for your NBG334W.
15.1 Static Route Overview
Each remote node specifies only the network to which the gateway is directly connected, and
the NBG334W has no knowledge of the networks beyond. For instance, the NBG334W knows
about network N2 in the following figure through remote node router R1. However, the
NBG334W is unable to route a packet to network N3 because it doesn't know that there is a
route through the same remote node router R1 (via gateway router R2). The static routes are
for you to tell the NBG334W about the networks beyond the remote nodes.
Figure 84 Example of Static Routing Topology
15.2 IP Static Route Screen
Click Management > Static Route to open the IP Static Route screen. The following screen
displays.