ZyXEL Communications NBG334W - Manual (Page 37)

Chapter 2 Introducing the Web Configurator
NBG334W User’s Guide
37
2.3 Resetting the NBG334W
If you forget your password or IP address, or you cannot access the web configurator, you will
need to use the RESET button at the back of the NBG334W to reload the factory-default
configuration file. This means that you will lose all configurations that you had previously
saved, the password will be reset to “1234” and the IP address will be reset to “192.168.1.1”.
2.3.1 Procedure to Use the Reset Button
1 Make sure the power LED is on.
2 Press the RESET button for five seconds or until the power LED begins to blink and
then release it. When the power LED begins to blink, the defaults have been restored and
the NBG334W restarts.
2.4 Navigating the Web Configurator
The following summarizes how to navigate the web configurator from the Status screen in
Router Mode and AP Mode.
2.5 The Status Screen in Router Mode
Click on Status. The screen below shows the status screen in Router Mode.
(For information on the status screen in AP Mode see
Chapter 4 on page 64 .)