Static route, 1 configuring static routing, Chapter 26 static route – ZyXEL Communications GS-4024 User Manual

Page 225: Figure 118 static routing, Table 81 static routing, Static route (225)

Advertising
background image

GS-4012F/4024 User’s Guide

225

C

H A P T E R

2 6

Static Route

This chapter shows you how to configure static routes.

26.1 Configuring Static Routing

Static routes tell the Switch how to forward IP traffic when you configure the TCP/IP
parameters manually.

Click IP Application, Static Routing in the navigation panel to display the screen as shown.

Figure 118 Static Routing

The following table describes the related labels you use to create a static route.

Table 81 Static Routing

LABEL

DESCRIPTION

Active

This field allows you to activate/deactivate this static route.

Name

Enter a descriptive name (up to 32 printable ASCII characters) for identification
purposes.

Destination IP
Address

This parameter specifies the IP network address of the final destination. Routing is
always based on network number. If you need to specify a route to a single host, use
a subnet mask of 255.255.255.255 in the subnet mask field to force the network
number to be identical to the host ID.

IP Subnet
Mask

Enter the subnet mask for this destination.

Gateway IP
Address

Enter the IP address of the gateway. The gateway is an immediate neighbor of your
Switch that will forward the packet to the destination. The gateway must be a router
on the same segment as your Switch.

Advertising
This manual is related to the following products: