Xerox 4090 - Manual (Page 114)

PRINTER MAINTENANCE
The fifth line reflects the status of the remote input source if the
system has one and it is active; otherwise, this line is blank.
The meanings of status codes displayed on the fourth and fifth
lines are shown in table 6-1.
Table 6-1. Status display information
Iiii Input status
WAIT Waiting for a job
TAPE Processing a tape job
DISK Processing a disk job
HOST Processing an online job
HIP Processing a HIP job
SDI Processing an SDI job
Oooo Output status
WAIT Waiting for a job
JAM Printer jammed and must be cleared
PRsd
Actively printing: source and destination are
indicated by “sd”
IDLE Neither input nor output processing is active
Host Remote source
HOST IBM channel host (through online/XPAF)
XNS Ethernet host
871 871-CM host
DMR DMR-11 host
XPS Xerox Print Services Manager
Stat Remote source status
OFFL No communication between host and LPS
NRDY
Communication established but LPS not ready
to receive data or commands from host
WAIT
LPS ready and waiting for data or commands
from host
RECV
LPS actively receiving data or commands from
host
SEND Host actively sending data or commands to LPS
SPND
LPS has suspended communication with the
host
ONLP LPS pending receipt from host
SESN Active XNS session
If the remote source is a host computer and the printer needs
your intervention, the host is notified through status information,
and the third line is replaced by the following message:
A T T N
.
6-26 XEROX 4050/4090/4450/4650 LPS OPERATOR GUIDE