Xerox 4090 - Manual (Page 156)

METER READING AND REPORTING
c. If you want to review the data before ending the
reporting session, enter **1# to start the review. Refer
to the “Reviewing and changing data” section, next, for
instructions.
Note: If you would like to practice with an imaginary serial
number before entering your actual serial number and meter
read, you can use serial number X12377889 (which converts
to *9212377889). This serial number is only a demonstration
serial number; it cannot generate a bill. All procedures
described in the “Entering meter read information” section
may be practiced with this serial number.
Reviewing and changing data
1. To begin the review, enter **1#. The system reads the first
serial number.
2. To accept the serial number and continue, enter#. The
system then reads back the A meter read.
3. Continue the review by accepting with the # sign each time
the entry is read back correctly.
If an entry is read back incorrectly, enter **4# to cancel the
entry and reenter the correct information after the voice
prompts you to do so. Make sure to wait until the voice is
finished before making entries.
4. To end the review at any time, enter **2#. When you end
the review, the system asks you to enter the # sign to
acknowledge the entries as complete. You may then choose
to enter more machine information or terminate the session.
Refer to step 6 in the previous section.
B-8 XEROX 4050/4090/4450/4650 LPS OPERATOR GUIDE