Xerox 4090 - Manual (Page 53)

4. Printing jobs
This chapter explains the procedures for setting up paper trays,
processing a print job, and checking print status displays.
Printing task flow overview
The following table shows the sequence of tasks involved in
overseeing a print job.
Table 4-1. Printing task flow overview
Tasks
Set up print job
source
Procedure Chapter and section
Offline jobs 1. Load the job tape. 3 “Loading an 18-track cartridge tape”
3 “Using the 9-track magnetic tape
drive”
2. Place the tape drive online. 3 “Receiving offline jobs”
Online jobs 1. Establish communication with the
host:
Channel-attached host:
Place the LPS online. 3 “Communicating with the channel-
attached host”
Network environment:
Start HIP. 3 “Communicating through the host
interface processor”
SDI jobs 1. Set the SDI online.
2. Start SDI.
3. Send the job from the front end.
3 “Communicating through the Shared
Disk Interface processor”
Run the print job 1. Set up feeder tray. 4 “Setting up feeder trays”
2. Set up output trays. 4 “Setting up output trays”
3. Print a sample, if desired: 4 “Printing samples”
— Change paper size,, if
necessary.
5 “Changing paper size”
— Change form alignment, if
necessary.
5 “Adjusting form alignment”
4. Start the job. 4 “Starting a print job”
5. Check job and queue status. 4 “Checking job and printer status”
XEROX 4050/4090/4450/4650 LPS OPERATOR GUIDE 4-1