Yamaha HTR-6090 - Manual (Page 118)

114
En
USING MULTI-ZONE CONFIGURATION
3
Refer to “Selecting the input source of Zone
2”, “Adjusting the volume level of Zone 2”,
“Adjusting the balance of the speaker level in
Zone 2” or “Adjusting the tonal quality of
Zone 2” on page 116 to perform further
operations.
Remote control operations
1
Set the operation mode selector to AMP and
then press SELECT k repeatedly to select
“ZONE 2”.
“ZONE 2” is displayed in the display window on the
remote control.
2
Refer to “Selecting the input source of Zone
2”, “Adjusting the volume level of Zone 2”,
“Adjusting the balance of the speaker level in
Zone 2” or “Adjusting the tonal quality of
Zone 2” on page 116 to perform further
operations.
3
Press SELECT k / n to exit from the Zone 2
mode.
■ Turning on or off Zone 2 using the
remote control
POWER and STANDBY on the remote control work
differently depending on the selected zone that appears in
the display window on the remote control.
• When the main zone or Zone 2 mode is selected, you
can turn on the main zone or Zone 2 or set them to the
standby mode individually.
• When the all mode is selected, pressing POWER turns
on the main zone or Zone 2 simultaneously and
pressing STANDBY sets them to the standby mode
simultaneously.
• When the remote control is in the main zone mode, “MAIN”
appears for a few seconds when POWER or STANDBY is
pressed.
• “ALL” appears in the display window on the remote control
only when SELECT n is pressed.
SELECT
TV
SOURCE
AMP
Control mode Display window
POWER
and
STANDBY
Main zone
mode
Name of the selected
input area
Turns on the main
zone only or sets it to
the standby mode.
Zone 2 mode
“ZONE 2” or “2;name
of the selected input
area” Turns on Zone 2 or
sets it to the standby
mode.
All mode “ALL”
POWER: turns on
the main zone and
Zone 2.
STANDBY: sets the
main zone and Zone
2 to the standby
mode.
Notes
01EN_00_HTR-6090_U.book Page 114 Tuesday, June 27, 2006 6:40 PM