Connecting to an external device, Remote connection ([remote] connector), Remote connection ([remote] connector). 28 – Yamaha DME24N User Manual

Page 28

Advertising
background image

Connecting to an External De

vice

Remote Connection ([REMOTE] Connector)

DME64N/DME24N Owner’s Manual

28

Remote Connection ([REMOTE] Connector)

The [REMOTE] connector of the DME64N/24N can be connected to remotely-controllable Yamaha AD8HR
or AD824 head amplifiers (pre-amps), digital mixers, or RS-232C compatible controllers (such as those from
AMX or Crestron). The [REMOTE] connector also transmits and receives MIDI messages.

Controlling external head amplifiers from the DME64N/24N

You can remotely control the AD8HR or AD824 head amplifier settings from DME Designer. Up to eight
AD8HR/AD824 head amplifiers can be connected.
When connecting an AD8HR or AD824 be sure to set the “Utility” screen “MISC” page (see manual page 49)
“Remote” parameter to “HA Control (RS422)”. Also, do change to any other setting than “HA Control
(RS422)” while the unit is connected. Doing so can damage the unit.
When connecting to a combination of AD8HR and AD824 head amplifiers, be sure to place the AD8HR units
closest to the DME64N/24N in the chain, otherwise the AD8HR or AD824 unit(s) may not be properly rec-
ognized by the DME64N/24N.

Connecting to an External Device

NOTE

Only control signals are transmitted and received via the REMOTE connection. Audio connections must be made separately.

D-SUB 9-pin Cable (Interlink Crossover)

REMOTE

HA REMOTE 2

HA REMOTE 1

HA REMOTE 1

HA REMOTE 2

AD8HR

AD8HR

AD824

AD824

AD824

DME64N/24N

COM PC/RS-422

COM RS-422

COM PC/RS-422

COM RS-422

COM PC/RS-422

Set to HA Control
(RS-422)

Advertising
This manual is related to the following products: