EVS XSense Version 10.04 - January 2011 Operating Manual - Manual (Page 157)

Issue
10.04.A XSense – Version 10.04 – Operating Manual
EVS Broadcast Equipment – January 2011
148
13.4.2 H
OW TO
N
AME A
R
EMOTE
C
LIP
1. Select the Clip mode in the Network menu.
2. Select the remote EVS server in the list.
3. Go to the Clip screen on the VGA, all banks of remote system are now
displayed.
4. Select the clip to name.
5. Type the desired name on the keyboard.
6. Press F1 to name the remote clip.
→ In CAM mode, only the camera where the cursor is located is named
→ In CLIP mode, all cameras of the clip where the cursor is located are
named.
Note
To be able to rename a clip on a remote server, the Clip Edit by Network
parameter must be enabled in the Setup menu.
13.4.3 H
OW TO
M
ODIFY
IN/O
UT
P
OINTS OF A
R
EMOTE
C
LIP
1. Recall the desired clip.
2. Browse inside the clip until you reach the desired frame.
3. Press IN / OUT to mark a new Short IN / Short OUT points.
Note
To be able to trim a clip on a remote server, the Clip Edit by Network
parameter must be enabled in the Setup menu of the remote machine.