EVS XSense Version 10.04 - January 2011 Operating Manual - Manual (Page 42)

XSense – Version 10.04 – Operating Manual
EVS Broadcast Equipment – January 2011
Issue
10.04.A
33
How to Configure the Video Delay Parameters of a Play
Channel
1. Select the play channel to configure by pressing ALT+ the corresponding F_
key on the PC keyboard (ex: ALT+F1 for PGM1, ALT+F2 for PGM2/PRV, etc)
2. If you want to use another server on the SDTI network as a source, press
SHIFT-F7 on the PC keyboard to call up the network list. Use the arrow keys
to select a server, and press ENTER to validate.
3. Select the camera angle: use the left / right arrow keys, or the <TAB> key to
move the green cursor on the desired camera, then press ENTER. The new
camera angle is loaded on the channel.
4. Set the new value for the delay: use the left / right arrow keys, or the <TAB>
key to move the green cursor over the TARGET DELAY field, and enter the
desired delay value in hh:mm:ss:fr. Press CTRL + the corresponding F_ key on
the PC keyboard to activate the new delay on the selected channel (ex: CTRL
+ F1 start the new delay on PGM1). If the duration of the record train is lower
than the target delay, the channel will pause on the first recorded picture until
the record train is long enough for the desired delay. In this case, the
message “WAIT” is displayed on the OSD of that channel.