EVS MulticamLSM Version 10.01 - July 2009 Operating Manual - Manual (Page 43)

Issue
10.01.F EVS Multicam Version 10.01 – Operating Manual
EVS Broadcast Equipment SA – July 2009
34
8. Video Delay
When the Multicam software has been configured with a base configuration =
Video Delay in the Channel Parameters menu, the Delay Screen will appear
automatically when the application is started. In this case, all play channels
will be available from the Delay screen.
If Multicam is running a base configuration different than Video Delay, this
screen can be called manually from the Clip screen, Playlist Screen or
Network Screen by pressing SHIFT-F7 on the keyboard. In this case, only
the play channels assigned to user #1 (i.e. the 1
s t EVS Remote Panel if the
base configuration is LSM or maXS, or the 1 s t protocol if the base
configuration is in slave mode).
For each play channel, the operator can adjust:
• the video and audio source (camera angle, and source server if several
units are connected on an SDTI network);
• the desired delay in hh:mm:ss:fr.
For each play channel, the operator can view:
• the actual delay in hh:mm:ss:fr;
• the timecode of the on-air picture
• the timecode of the incoming picture on the associated record channel;
• the status of the associated record channel (Recording / Idle)