EVS XTnano Version 10.04 - January 2011 Operation Manual - Manual (Page 46)

Issue
10.04.A XTnano – Version 10.04 – Operating Manual
EVS Broadcast Equipment SA – January 2011
38
8.2.8 H
OW TO
S
HORTEN A
C
LIP
To shorten a clip, proceed as follows:
1. Recall the desired clip by pressing the corresponding F_ key.
2. Move the jog dial to browse the clip and reach to the desired Short IN point.
3. Press the IN key to mark a new Short IN point. The new Short IN point is
instantly saved.
4. Move the jog dial to reach the desired Short OUT point.
5. Press the OUT key to mark a new Short OUT point. The new Short OUT
point is instantly saved.
Move the lever or press the PLAY key to play the clip. The replay will stop at the
new Short OUT point (or after the Short OUT point if the Post-Roll mode is
enabled).
Goto IN and Goto OUT
You can use Goto IN and Goto OUT functions to jump immediately onto Short IN
or Short OUT points respectively.
8.2.9 S
ECONDARY
M
ENU IN
C
LIP
M
ODE
O
VERVIEW
In Clip mode, the secondary menu of the Remote Panel is different from the
Record Train mode:
Press MENU to access the secondary menu, the LCD display will be:
1keyword890123 2 keyword89012 3 keyword89012
111A
Push Aux Clip PostRoll
>Archive Cam
PGM1 112A *PRV1* 112B
Push Aux Clip PostRoll
>Archive Cam
P.1 B.1
PL 11: < >
Msg:
Rst Cam Sync Prv
Cam A Cam B Cam C