StreetGlow LED Tubes - Manual

Installation Instructions
Step 1 Mount the L.E.D. Tube in the desired
location using the double sided tape
provied.
Step 2 Make connection of power (+) and
ground (-) wiers.
STRIPED wire = 12v battery (+)
BLACK wire = negative ground (-)
NOTE: L.E.D. Tube is able to be animated by the L.E.D.
Digital Pattern Controller (SGLC4, sold separately). To
connect the unit to the controller, simply unplug the
power adapter cable and plug the control wire into one
of the available ports on the back of the SGLC4 (see
SGLC4 instructions for details).
CONTENTS:
1 - 3" L.E.D. Tube
1 - Power Adapter Cable
All necessary mounting hardware
3" LED TUBE
Design and specifications are subject to change without notice.
The retailer shall not be held responsible for any damages that occur as a result of defective products.
StreetGlow products are recommended for show and off-road use only. Laws concerning the use of aftermarket
lighting products may vary from state to state. For more information, please check with your local authority.
3"
L.E.D.
Tube
Power
Adapter
Cable