Pro Series 51080 51 Receiver - Manual

Installation Instructions
Toyota Sienna
Part Numbers:
51080
Do Not Exceed Lower of Towing Vehicle Fascia
Toyota Sienna
2011 and newer models: Hitch crosstube is visible beneath
bumper with a more than normal gap between fascia and crosstube.
Hitch Shown In Proper Position
Equipment Required:
Manufacturer’s Rating or
Wiring Access Location: SUV1, SUV2
Frame Rail
Hitch type
Max Gross
Trailer WT (LB)
Max Tongue
WT (LB)
Weight Distributing 5,000 500
Weight Carrying
Ball Mount
3,500 350
To be reinstalled
Wrenches: 19mm
Drill Bits: None
Fastener Kit: 51080F
Existing Weldnut
3 Places
(Both Sides)
Note:
Area to be trimmed
To be reinstalled
Fasteners Typical
Both Sides
Area to be trimmed
To be reinstalled
Figure 2
Sport Model
1 Qty. (6) Flat Washer, 1/2” 3 Qty. (6) Hex Bolt, M12 x 1.25 x 40mm
2 Qty. (6) Lock Washer, 1/2”
Area to be trimmed
Figure 1
For vehicles with appearance panel:
Remove appearance panel which covers the trunk pan. This panel will need to be trimmed or not reinstalled on vehicle. Ask vehicle
owner their choice before starting installation. See Figure 2
1. Lower the exhaust by detaching it from the rubber isolator.
2. Raise hitch into position and install hex bolts, lock washers and flat washers into existing weldnuts in frame, as shown above.
3. Raise exhaust back into position and reattach to the rubber isolator.
4. Reinstall trimmed cover panel removed. Or return untrimmed panel to vehicle owner.
z 2007, 2010, 2011 Cequent Performance Products Sheet 1 of 3 51080N 1-7-11 Rev. C
Tighten all M12 CL10.9 fasteners with torque wrench to 75 Lb.-Ft (102 N-m).
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.