Pro Series 51156 51 Receiver - Manual

Installation Instructions
Honda Odyssey
Part Numbers:
51156
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 18mm
Drill Bits: None
1999-2004 Models
Use forward slot
Existing weld nuts
1. Lower vehicle exhaust and raise hitch into position.
2. Install the six (6) M12 fasteners as shown above.
Note: 1999-2004 models use the most forward slots in the hitch side brackets.
3. Re-install vehicle exhaust.
Rev. A 8-17-09 51156N Sheet 1 of 3 z 2009 Cequent Performance Products
Conical Washer Qty. (6) 2 Bolt M12 X 1.25 X 35mm Qty. (6) 1
Tighten all M12 Cl8.8 fasteners with torque wrench to 68 Lb.-Ft. (92 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Fastener Kit: 51156F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
350 (159 Kg) 3500 (1589 Kg)
Weight Carrying
Ball Mount
500 (227 Kg) 5000 (2270 Kg) Weight Distributing
Max Tongue
WT (LB)
Max Gross
Trailer WT (LB)
Hitch type
Wiring Access Location: SUV3
Form: F205 Rev A 5-6-05
Frame rail
2005 & Later Models
Installation shown
Fascia
Frame rail
2
1
Note: Fasteners typical both sides