Pro Series 97159 51 Receiver User Manual

Fasteners typical both sides of vehicle, Installation instructions, Acura mdx honda pilot

Advertising
background image

Installation Instructions

Acura MDX

Honda Pilot

Part Numbers:

51159

97159

Hitch Shown In Proper Position

Equipment Required:

Wrenches: 10mm, 14mm, 17mm, 19mm

Drill Bits: None

Note:

Transmission cooler and Power Steering cooler are required for max. towing capacity (See vehicle owner’s manual for details).

2001-2003 Acura MDX & 2001 and later Honda Pilot:

1.

Remove tow hook from driver’s side of vehicle and return hook and fasteners to vehicle owner.

2.

Lower exhaust by removing three rubber muffler hangers.

3.

Raise hitch into position and install fasteners as shown above.

4.

Reinstall muffler hangers removed in step 2.

5.

If exhaust rattle occurs, trim rearward exhaust heat shield between crosstube and muffler.

2004 Acura MDX

1.

Remove tow hook from driver’s side of vehicle and return hook and fasteners to vehicle owner.

2.

Remove fascia under covering by removing bolts and fascia clips shown above and return to vehicle owner.

3.

Lower exhaust by removing four rubber muffler hangers.

4.

Raise hitch into position and install fasteners as shown above.

5.

Reinstall muffler hangers removed in step 3.

©

2009, 2012, 2013 Cequent Performance Products

– Printed in Mexico

Sheet 1 of 3

51159N

10-24-13

Rev. C

j

Qty. (6)

Hex Bolt M12 x 1.25 x 35mm CL8.8

k

Qty. (6)

Conical Washer

– ½”

Tighten all m12 x 1.25 CL8.8 fasteners with torque wrench to 68 Lb.-Ft.

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent
entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a
vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and
SAE J684.

Fastener Kit: 51159F

Do Not Exceed Lower of Towing Vehicle

Manufacturer’s Rating or

Hitch type

Max Gross

Trailer WT (LB)

Max Tongue

WT (LB)

Weight Distributing

5000 (2270 Kg)

500 (227 Kg)

Weight Carrying

Ball Mount

3500 (1589 Kg)

350 (159 Kg)

Wiring Access Location: SUV3

Form: F205 Rev A 5-6-05

Bumper

Fascia under covering
(some models)

Existing weldnuts
(both sides)

Frame Rail

jk

Fasteners Typical Both
Sides of Vehicle

Fits with mini spare tire stowed under vehicle. Will not fit with full size spare.

Advertising