Symbol definitions – Extron Electronics DVS 605 User Guide User Manual
Page 42
Symbol Definitions
• = Space
] = Carriage return with line feed
¦ or
} = Carriage return with no line feed
E
or W
= Escape
14, 24, 28
= Superscripts indicate the error message displayed if the command is entered
incorrectly or with invalid parameters.
See “Error Response References,”
X! = Input selection, 1-5, (0 = current input — 0 is valid only for Input Config settings:
0 = main when PIP is disabled, 0 = PIP when PIP is enabled)
X@ = Output selection:
0 = All outputs (default)
1 = Analog (VGA, YUVp, HDTV)
2 = HDMI
3 = 3G/HD-SDI
4 = None
X#
= Input video format:
0 = No signal detected (only valid for detected input format query, such as X!*\ or “ I”)
1 = RGB
5 = Composite video
2 = YUV auto
6 = DVI/HDMI (available only for inputs 3, 4, and 5)
3 = RGBcvS 7 = Auto detect (default for inputs 1 and 2)
4 = S-video
X$
= Horizontal/vertical start — 0 to 255 (default midpoint = 128)
X%
= Pixel phase — 0 to 63 (default = 31)
X^
= Total pixels — ±512 of the default value
X&
= Active pixels — ±512 of the default value
X*
= Active lines — ±512 of the default value
X(
= Enable/disable: 0 = Off/disable, 1 = On/enable
X1)
= Input standard:
0 = No signal detected
3 = NTSC 4.43
1 = NTSC 3.85
4 = SECAM
2 = PAL
- = N/A (occurs when input is an active RBG, YUV auto [but not NTSC/PAL], or HDMI signal)
X1!
= Internal temperature (in degrees Celsius)
X1@ = Unit name is a text string of up to 24 characters drawn from the alphabet (A-Z), digits (0-9),
and the minus sign/hyphen (-). The first character must be an alpha character. The last
character must not be a minus. No blank or space characters are permitted, and no distinction
is made between upper- and lowercase.
X1#
= Horizontal and vertical frequencies (format is three-digit with single decimal and leading zeros
for example, 075.3
)
X1$
= Text label/preset name:
up to 16 characters
NOTE:
User and input presets saved without a name are saved with the default names
“User Preset xx” (for example, User preset 12) or “Input preset xxx” (for example,
input preset 122).
X1%
= Picture adjustment — 0 to 127 (default = 64
)
X1^ = Horizontal and vertical position,
±11000,
with leading “+” or “-”, for example “- 02040”
DVS 605 • SIS Communication and Control
36