Extron Electronics DVS 605 User Guide User Manual
Page 60
Command
ASCII Command
(host to scaler)
Response
(scaler to host)
Additional Description
Hardwired IR port
Enable IR port
(allows IR)
65*0#
IRDisable0
]
Enables the hard wired port and allows IR
control input.
Disable IR port
(blocks IR)
65*1#
IRDisable1
]
Disables the hard wired port (default).
View IR setting
65#
X(
]
View the current IR Disable setting.
Picture In Picture
NOTE:
HDMI input 5 cannot be used for PIP.
PIP on/off
PIP on
E
X2&
PIP}
Pip
X2&]
Turn on PIP and display input
X2&
.
X2&
is a
two digit response (for example, 01).
PIP off
E
0
PIP}
Pip
00]
Turn PIP off.
View PIP selection
E
PIP}
X2&]
View PIP selection (
X2&
is a two digit
response, for example, 01).
Swap main/PIP windows
Swap
%
Tke
]
Swap between main and PIP window
.
On-Screen Menu time-out
NOTE:
Setting the time-out to 501 disables the OSD time-out (never times out). Setting the time-out to 0 disables the OSD.
Set menu time-out
E
X2%
MDUR}
MdurX2%
]
Set the OSD to
X2%
seconds.
View time-out
E
MDUR}
X2%
]
View time-out settings.
Reset commands
Erase user web
pages and files
24 28
E
<filename>EF}
Del•<filename>]
Erase named files.
Erase current
directory and
files
24 28
E
/EF}
Ddl]
Erase current directory and its files.
Erase current
directory and
subdirectories
24 28
E
//EF}
Ddl]
Erase current directory and its
subdirectories.
Erase flash
memory
24
E
ZFFF}
Zpf]
Erase the flash memory.
Reset all device
settings to factory
default settings
24
E
ZXXX
}
Zpx
]
Retains Ethernet settings
Absolute system
reset
24
E
ZQQQ
}
Zpq
]
Includes resetting networking to DHCP =
Off, IP = 192.168.254.254 (default address)
Absolute system
reset (but retain IP)
24
E
ZY
}
Zpy
]
NOTE:
This reset
E
ZY is similar to ZQQQ but excludes IP address, subnet mask, gateway addresses, unit name,
DHCP setting, and port mapping (Telnet/web/direct access) in order to maintain communications with device.
Recommended after a firmware update.
NOTE:
X( = Enable/disable: 0 = off/disable, 1 = on/enable
X2% = On-screen menu time-out: (default = 3 seconds)/output sync time-out (default = 501 - never)
0 = OSD never displayed/output sync is instantly disabled with no active input,
1 to 500 in 1 second increments, 501 = OSD never times out/output sync never times out
X2& = PIP window input selection: 0 to 4 (0 = off)
DVS 605 • SIS Communication and Control
54