Elmo Rietschle 2FC4...-1CB - Manual (Page 12)

3 Safety and responsibility
610.00260.40.000 · 05.2014 12 / 74 © Gardner Denver Deutschland GmbH
Disassembly and Disposal
Screw and snap-on connections are easy to release and allow the drive
control to be dismantled into its individual parts. These parts can be sorted
for recycling. Please comply with local regulations during disposal.
Components with electronic parts may not be disposed of along with nor-
mal household waste. They have to be collected separately with used elec-
trical and electronic equipment in accordance with applicable legislation.
Correct use of the equipment
During installation in machinery, commissioning of the drive controller (i.e. starting
of intended operation) is prohibited until it is proven that the machine complies
with the regulations of the EC Directive 2006/42/EC (Machinery Directive); EN
60204-1:2006 is to be observed.
Commissioning (i.e. starting of intended operation) is only permitted if the EC Di-
rective 2004/108/EC (EMC Directive) allows it.
The harmonised standards of the series EN 50178:1997 in conjunction with EN
60439-1/A1:2004 shall be applied to this drive controller.
This drive controller is not approved for operation in potentially explosive areas!
Repairs may only be carried out by authorised repair workshops. Unauthorised in-
terventions can lead to death, bodily injury and property damage. The warranty
provided by the manufacturer expires in this case.
External mechanical loads, such as stepping on the casing are not allowed!
The use of the drive units in non-stationary equipment is considered as un-
usual environmental conditions, and is permitted only in accordance with
the locally applicable standards and guidelines.
Staff qualifications and training
All those who will work on the must have read and understood these instructions
and the related documents [➙ 6].
Personnel in training may only work on the under supervision of personnel who
have the required knowledge.
Only allow work on the to be carried out by personnel with the following knowl-
edge:
In the context of this operating manual and the information relating to the product
itself, qualified staff refers to electronic specialists who are familiar with the instal-
lation, assembly, start-up and operation of the drive control and the dangers in-
volved, and whose specialist training and knowledge of relevant standards and
regulations provide them with the necessary abilities.
3.2.7
3.3
3.4