B&K Precision XLN60026 - Manual - Manual (Page 148)

52
Example 1:
To output the waveform shown above, users may edit the program through
the following commands:
PROG 1 Choose program number
PROG:CLE Clear program 1 data
PROG:REP 0 No repeat (repeat one time for “1”)
PROG:TOTA 8 Set program 1 to have 8 steps in total
PROG:STEP 1 Following 3 settings are for step 1
PROG:STEP:CURR 2 Set output current to 2 ampere
PROG:STEP:VOLT 50 Output voltage is set to 50 volts
PROG:STEP:ONT 0.5 Output ON time is set to 0.5 sec
PROG:STEP 2 Following 3 settings are for step 2
PROG:STEP:CURR 2
PROG:STEP:VOLT 100
PROG:STEP:ONT 0.5
PROG:STEP 3 Choose step 3
PROG:STEP:CURR 2
PROG:STEP:VOLT 150
PROG:STEP:ONT 0.5
PROG:STEP 4 Choose step 4
PROG:STEP:CURR 2
PROG:STEP:VOLT 200
PROG:STEP:ONT 0.5
PROG:STEP 5 Choose step 5
PROG:STEP:CURR 2
PROG:STEP:VOLT 150