Datamax-O'Neil E-Class Mark III Operator’s Manual - Manual (Page 53)

Chapter 4 – Menu System 47
DISPLAYED ITEM ITEM DESCRIPTION
NETWORK/BLUETOOTH Controls the communications settings for the network and Bluetooth interfaces, where:
ACTIVE INTERFACE Selects the network interface currently in use by the printer, where:
NONE Disables all interfaces
WIRED
ETHERNET
Selects the Wired Ethernet interface
WIRELESS
ETHERNET
Selects the Wireless Ethernet interface (if installed)
BLUETOOTH Selects the Bluetooth interface (if installed)
WIRED ETHERNET Controls the communications settings for the wired Ethernet network interface
IP DISCOVERY Sets the address discovery method, where:
USE STATIC
ADDRESSES
The stored static IP, Subnet Mask, and / or Gateway Address will be used.
USE DHCP The card broadcasts over the network using DHCP protocol to receive addresses from the
responsible server at startup. Manual modifications to IP Address, Subnet Mask, or Gateway Address
are not allowed; and, if no server is found, the specified static value will be used. (Default Setting)
 A server assigned IP address takes precedence over any static IP address
stored in the interface.
USE BOOTP The card broadcasts over the network using BOOTP protocol to receive addresses from the
responsible server at startup. Manual modifications to IP Address, Subnet Mask, or Gateway Address
are not allowed; and, if no server is found, the specified static value will be used. (Default Setting)
 A server assigned IP address takes precedence over any static IP address
stored in the interface.
STATIC IP
ADDRESS
Specifies the static IP Address of the interface in the standard octet format.
STATIC SUBNET
MASK
Specifies the static Subnet assigned to the interface, for example:255.255.255.000.
STATIC
GATEWAY
Specifies the Gateway Address the interface will use, for example:192.168.10.1
DUPLEX
CAPABILITY
Specifies the transmission and speed of the wired Ethernet connection:
• Auto-Negotiate (default);
• 10 BaseT Half Duplex
• 10 BaseT Full Duplex
• 100 BaseT Half Duplex
• 100 BaseT Full Duplex
PRIMARY WINS
SERVER
The IP address of the primary WINS Server.
SECONDARY
WINS SERVER
The IP address of the secondary WINS Server.
PRIMARY DNS
SERVER
The IP address of the primary DNS Server.
SECONDARY
DNS SERVER
The IP address of the secondary DNS Server.
SNMP TRAP
ADDRESS
Is the address in standard octet format where SNMP traps will be sent when SNMP service is
installed on your receiver. When zeroed, no traps are sent.
SNMP SERVER
ADDRESS
Is the server address in standard octet format for SNMP services.
NETBIOS
ENABLE
Enables or disables the NET BIOS SERVICES
NO (Default Setting)
YES
TCP PRINT PORT Selects the Port to use for all TCP network communications; Default is 9100
INACTIVITY TIME Set the amount of time (in seconds) in which the current port will remain open when no activity is
present.
LPD PRINT PORT Selects the Port to use for all LPD network communications; Default is 515