Datamax-O'Neil E-Class Mark III Operator’s Manual User Manual
Page 61
Chapter 5 – Maintenance and Adjustments
55
5
5
5
.
.
.
4
4
4
A
A
A
d
d
d
j
j
j
u
u
u
s
s
s
t
t
t
a
a
a
b
b
b
l
l
l
e
e
e
M
M
M
e
e
e
d
d
d
i
i
i
a
a
a
S
S
S
e
e
e
n
n
n
s
s
s
o
o
o
r
r
r
The optional Adjustable Media Sensor (AMS) allows the printer to accept a wider variety of media
configurations. The table below defines general AMS positions for various media and Top of Form (TOF) types.
AMS Positioning
Media Type
Sensor Location
TOF Sensing Method
Continuous
Any location in the media path with
both sensors aligned.
Continuous
(Only detects out of media)
Die-Cut
Any location within the media path
where the gap between the labels
crosses the sensors. (top and bottom
sensors must be aligned)
Separate Die Cut and
Notched. Use this for the
Notched or Hole Media
Notched/Hole
Center of the Notch or Hole
Gap (primary)
Reflective (secondary)
Black Bar
Center of the Black Mark
Reflective
Position the AMS as follows:
1) On the Bottom AMS Sensor, identify the proper Indicator for
use with your media.
Gap or Notch Indicator
Reflective (Mark) Indicator
2) Slide the Bottom AMS sensor so the Indicator is in line with the center of the notch, gap, or
reflective (mark) of the installed media.
3) Slide the Top AMS Sensor over to the same setting as the Bottom AMS Sensor, (this is not
necessary if using reflective media).
312
Bottom AMS Sensor
Top AMS Sensor
4) Load media, see Section 2.3.