CognitiveTPG A798 - Manual (Page 69)

Chapter 4: Programming Commands 69 Revision C 12/09
A798-PG00001C
Transmit printer ID, remote diagnostics extension
ASCII GS I @ n
Hexadecimal 1D 49 40 n
Decimal 29 73 64 n
Values of n: Refer to table
Range of n: 32–255 (not all defined, but reserved)
Eighteen remote diagnostic items are defined in the following table: eight printer ID items and ten printer tally items. A
group of four remote diagnostic functions is assigned to each diagnostic item. Most of the diagnostic items are maintained
in non-volatile memory (NVRAM), but some are maintained in read-only memory (ROM).
The first item group in the table includes an example of data to send and to receive. Data sent from the host to write to
NVRAM must contain all digits required by the remote diagnostic item. All data must be ASCII. The printer returns all
ASCII data. It is preceded by the parameter n to identify the diagnostic item and is followed by a carriage return (0D) to
signify the end of the data.
Each returned message is defined as: n + data + <CR>
The command performs the remote diagnostic function specified by n as described in the following table.
Value of n
ASCII
Hex Dec Remote diagnostic item Function
Space 20 32 Serial #, 10 digit ASCII Write to NVRAM Example, send 14 bytes to printer:
GS I @ 0x20 1234567890
! 21 33 Serial # Write to NVRAM, and print on receipt to verify
Example, send 14 bytes to printer:
GS I @ ! 1234567890 This will print on receipt:
Serial # written: 1234567890
# 23 35 Serial # Return Serial #, preceded by n to identify Printer
returns 12 bytes in above example: #1234567890<CR>
$ 24 36 Class/model #, 15 digit ASCII Write to NVRAM
% 25 37 Class/model # Write to NVRAM, and print on receipt to verify
‘ 27 39 Class/model # Return Class/model #, returns 17 bytes
+ 2B 43 Boot firmware part #, 12 digit ASCII Return Boot firmware part #, returns 14 bytes
/ 2F 47 Boot firmware CRC, 4 digit ASCII Return Boot firmware CRC, returns 6 bytes
3 33 51 Flash firmware part #, 12 digit ASCII Return Flash firmware part #, returns 14 bytes
7 37 55 Flash firmware CRC, 4 digit ASCII Return Flash firmware CRC, returns 6 bytes
Ç 80 128 Receipt lines tally, Write to NVRAM Example, send 12 bytes to printer:
8 digit ASCII numeric, GS I @ Ç00010000 To set receipt lines tally to 10,000
max 99,999,999
ü 81 129 Receipt lines tally Write to NVRAM, and print on receipt to verify
Example, send 12 bytes to printer:
GS I @ ü00010000 This will print on receipt:
Receipt tally written: 10,000
é 82 130 Receipt lines tally Clear receipt lines tally to 0
â 83 131 Receipt lines tally Return receipt lines tally, preceded by n to identify
Printer returns 10 bytes in above example:
â00010000<CR>
ä 84 132 Knife cut tally, 8 digit ASCII numeric, Write to NVRAM
max 99,999,999
à 85 133 Knife cut tally Write to NVRAM, and print on receipt to verify