Luminex FLEXMAP 3D User Manual - Manual (Page 13)

FIGURE 1. MET Mark
In addition, Luminex FLEXMAP 3D complies with European Union (EU) safety requirements
and therefore may be marketed in the Europe Single Market. The following European Union
compliance label appears on the back of the FLEXMAP 3D instrument.
FIGURE 2. European Union Compliance Label
Safety Precautions
Read the following safety information before using the Luminex ® FLEXMAP 3D ® instrument.
This instrument contains electrical, mechanical, and laser components that, if handled
improperly, are potentially harmful. In addition, biological hazards may be present during
system operation. Therefore, Luminex recommends that all system users become familiar
with the specific safety advisories below in addition to adhering to standard laboratory safety
practices.
NOTE: In any situation in which you encounter this symbol, consult this
manual or other Luminex documentation to determine the nature of
the potential hazard and any necessary actions you must take.
CAUTION: The protection provided by the equipment can be impaired or the
warranty voided if the FLEXMAP 3D
® system is used in a
manner not specified by the instructions or by Luminex
Corporation.
General
CAUTION: Keep access doors closed during normal operation.
Always observe standard laboratory safety practices.
Electromagnetic Compatibility
The Luminex ® FLEXMAP 3D ® system complies with the emission and immunity requirements
described in IEC/EN 61326-1. The electromagnetic environment should be evaluated prior to
operation.
For research use only. Not for use in diagnostic procedures. Safety
3