PASCO EM-8656 AC_DC ELECTRONICS LABORATORY - Manual (Page 38)

34
AC/DC Electronics Laboratory 012-05892A
®
➂
Click on the Frequency value to highlight it. Type in “0.30” as the new value. Press the “enter” key.
➃
Click the Scope display to make it active.
• You will change the rate at which the scope is sampling data.
➄
Click the “Horizontal Input” button. Use the Horizontal Input menu to select “Time Input” (at the
bottom of the list).
Horizontal Input button Horizontal Input menu
➅ Repeatedly click the “Decrease Sweep Speed” button ( ) until the Sweep Speed is 500.00
ms/div.
➄ Click the “Horizontal Input” button again. Use the Horizontal Input menu to select “Analog A” (at
the top of the list).
Horizontal Input button Horizontal Input menu
• After making changes, the Scope display should be similar to the figure below: