Foredom M.402 - Manual

Owner’s Manual
FOREDOM ®
Arch Trimmer
M.400 (115 Volt) and M.402 (230 Volt)
For Your Own Safety–
Read the Owner’s Manual before operating
your Foredom Power Tool.
Always use the safety shield and wear eye protection
while using the Arch Trimmer or other power tools.
FOREDOM
The Foredom Electric Company www.foredom.com
®
Form 513A 3/10 n Printed in USA
LIMITED WARRANTY
The Foredom Electric Company warrants the Arch Trimmer to be free of defects in material or
workmanship for a period of 2 years after purchase. During the warranty period, the defective
product will be repaired or replaced without charge or, at our option, the purchase price will be refunded. This
warranty does not cover damage caused in transit or by accident, misuse, or ordinary wear.
ALL IMPLIED WARRANTIES, INCLUDING BUT NOT LIMITED TO WARRANTIES OF FITNESS AND
MERCHANTABILITY, ARE HEREBY LIMITED IN DURATION TO A PERIOD ENDING ONE YEAR FROM DATE OF
PURCHASE, AND WE WILL NOT BE LIABLE OR RESPONSIBLE FOR ANY SPECIAL OR CONSEQUENTIAL
DAMAGES.
Repair or replacement will be made at our option if the product is returned post-paid to:
The Foredom Electric Company, 16 Stony Hill Road, Bethel, CT USA 06801
All warranty repairs must be done at the factory at the above address. We will not pay any shipping or
transportation charges. This warranty only covers the original purchaser of the product. Some states do not allow
limitations on how long an implied warranty lasts, so the above limitations may not apply to you. This warranty
gives you specific legal rights, and you may also have other rights which vary from state to state.
Repair Service
Factory repairs are done promptly and at
reasonable cost. If you wish, you can send your
equipment directly to the factory marked Attention:
Service Dept. Be sure to give your street address
and phone number. The equipment should be
accompanied by a brief note describing the prob-
lem with the equipment. Estimates will be made
upon request.
Please retain your proof of purchase for
warranty repairs.
Cleaning, Maintenance & Parts
continued
Typhoon ® Burs: Long lasting, non-clogging tungsten
carbide burs with unique, structurally aligned points,
easily cleaned with supplied A-HB58 brass bur clean-
ing brush, a steam cleaner or ultrasonic cleaner.
M.400 comes with 2– 1/4 ″ shank coarse (red) burs–
Taper (5°) p/n A- KB14198 and Ball Nose A-KB14734 .
M.402 comes with 2– 6mm shank coarse (red) burs–
Taper (5°) p/n A-KB66198 and Ball Nose A-KB66734.
Other 1/4 ″ and 6mm shank burs available.
Sanding Bands: M.400 and M.402 are supplied with
3/4 ″ x 1 1 ⁄ 2
″ (19 x 38mm) 5 coarse, 5 extra fine sand-
ing bands, rubber drum mandrel (A-SD145 with
M.400, A-SD345 with M.402) Replacement bands
with finer grits also available.
Cylinder Sanding Bands 10-packs
60 grit coarse A-4942-10
80 grit medium A-4943-10
120 grit fine A-4944-10
220 grit extra fine A-4946-10
Carbon Brush Wear: Disconnect power cord before
checking for brush wear. Check for brush wear
about every 1000 hours or after approximately one
year of continuous operation. To access the motor,
the cover of the unit needs to be removed. Turn the
unit over and remove the screws embedded in the
four rubber feet. The brush tubes are located under
the two protective caps on the motor. Remove them
with a standard screw driver blade, unscrew the
brush tube caps, check the brush length, and install
new brushes if the old ones are less then 1/4 ″
(6mm) in overall length. Be sure the radius in the
end of the brush is in line and conforms to the com-
mutator surface. Replacement brushes are available
from your dealer or the factory. To order the correct
replacement motor brushes, find the part number
on your Arch Trimmer’s motor. See listing below:
Motor Brush
Motor No. Volts Part No. (Includes 2)
90-953 115V
MP319P
90-954 230V
33-1711 115V
MP2039P
33-1712 230V
Contact Information
If you have a warranty issue with your Foredom
power tool please use the contact information
below. For more information on Foredom
machines, handpieces or accessories, contact
your local dealer. When no local dealer is
available contact Foredom at:
The Foredom Electric Company
16 Stony Hill Road, Bethel, CT 06801
Tel.: (203) 792-8622
• Fax: (203) 796-7861
Email: [email protected]