KB Electronics KBMK-24DF - Manual (Page 32)

32
FIGURE 21
IODA TERMINAL BLOCK TB1 LAYOUT
Common Terminals "8", "12", "14", "16", "18, "20", "22" are all internally connected and are shown shaded.
TABLE 11
IODA FUNCTIONS, FEATURES, AND TERMINAL ASSIGNMENT
Terminal Assignment
Multi-Function
Input Terminal Codes MFIT 1
(Digital Inputs)
Power
Supply 2
Multi-
Function
Outputs 2
Analog
Outputs 2
Analog
Inputs
2
Relay
Outputs 3
0000: Preset Frequency Operation 1
0001: Preset Frequency Operation 1
0002: Preset Frequency Operation 1
0003: Up Frequency Command
(See Function No.7.14)
0004: Down Frequency Command
(See Function No. 7.14)
0005: Accel/Decel 2
(See Function No. 7.16)
0006: Forward/Stop Command
0007: Reverse/Stop Command
0008: External Fault (N.O. Contact)
0009: Reset
0010: N.O. Start
(2-Wire or 3-Wire Start/Stop)
0011: N.C. Stop
(3-Wire Start/Stop)
0012: External Fault (N.C. ontact)
1 – 7 8
Common
9
+5 Volts
10
-5 Volts
11
Open
Collector 1
12
Common
13
Open
Collector 2
14
Common
15
Analog Out 1
16
Common
17
Analog Out 2
18
Common
19
Analog In 1
20
Common
21
Analog In 2
22
Common
23
Relay 1 N.O.
24
Relay 1
Common
25
Relay 1 N.C.
26
Relay 2 N.O.
27
Relay 2
Common
28
Relay 2 N.C.
Notes: 1. Multi-Function Input Terminals "1" – "7" can be programmed for: 7 Preset Frequencies*, Up or Down
Frequency Command, Accel/Decel 2, Forward/Stop, Reverse/Stop, External Fault, Reset, and 2-Wire/3-Wire
Start/Stop. 2. Common Terminals 8, 12, 14, 16, 18, 20, and 22 are all internally wired together and can be used
with any of the Multi-Function Input Terminals "1" – "7". 3. Relay 1 Common (Terminal 24) is the contact common
only for Relay 1. Relay 2 Common (Terminal 27) is the contact common only for Relay 2.
*The 7 Preset Frequencies are obtained using a combination of Terminals 1, 2, 1+2, 3, 1+3, 2+3, 1+2+3.
TABLE 12
MULTI-FUNCTION INPUT TERMINAL, FUNCTION NO., AND CODE ASSIGNMENT
MFIT: 1 2 3 4 5 6 7
Function No.: 7.00 7.01 7.02 7.03 7.04 7.05 7.06
Factory Code Setting: 0000 0001 0002 0009 0010 0003 0004
Code Description:
Preset
Frequency
Operation
Preset
Frequency
Operation
Preset
Frequency
Operation
Reset
2-Wire
N.O.
Start/Stop
Up
Frequency
Command
Down
Frequency
Command
Each Multi-Function Input Terminal is controlled by a specific Function No.
Although factory set to a specific code, they can also be reprogrammed to any Function Code "0000" – "0012"
listed in Table 11, above. Also see Function Group 7, on page 26.