King Electric SR self-reg, cut to length - Manual (Page 12)

1 2
3 4
5 6
Open sealing fitting and slide the junction box sealing
fittings onto the end of the cable as shown above.
Lightly score completely around and then down
outer jacket a distance of 7”. Do not cut braid or inner
jacket. Bend heating cable to break jacket at score,
then peel off outer jacket!.
Cut the braid and push it back to loosen it as shown.
Bend the cable and gently pull it through the braid.
Twist and position the braid to one side of heating
cable and then cut the insulating jacket back 6”.
Lightly score the inner insulating jacket and then
bend the cable to break the jacket and peel it off.
Notch the conductive core at the end and twist it back
to peel the bus wires from the core. Score between the bus wires and bend the core to
break it free and peel the core material away from the
bus wires.
Rev 11.04.12 www.king-electric.com 12