4 internal peripheral device connections, 1 sata drive connection, Nternal – IEI Integration KINO-DH810 User Manual
Page 65: Eripheral, Evice, Onnections, Figure 4-7: sata drive cable connection
KINO-DH810
P a g e 53
4.4 In te rn a l P e rip h e ra l De vic e Co n n e c tio n s
This section outlines the installation of peripheral devices to the on-board connectors
4.4.1 S ATA Drive Co n n e c tio n
The KINO-DH810 is shipped with two SATA drive cable. To connect the SATA drive to the
connector, please follow the steps below.
S te p 1:
Locate the SATA connector and the SATA power connector. The locations of
the connectors are shown in Chapter 3.
S te p 2:
Insert the cable connector. Insert the cable connector into the on-board SATA
drive connector and the SATA power connector. See Figure 4-7.
Figure 4-7: SATA Drive Cable Connection
S te p 3:
Connect the cable to the SATA disk. Connect the connector on the other end
of the cable to the connector at the back of the SATA drive. See Figure 4-7.
S te p 4:
To remove the SATA cable from the SATA connector, press the clip on the
connector at the end of the cable.