4 clear cmos jumper – IEI Integration AFL-F08A v2.10 User Manual
Page 33
AFL-F08A-N270 Panel PC
Page 21
Figure 3-7: AT/ATX Power Selection Switch
3.7.4 Clear CMOS Jumper
Jumper Label:
J_CMOS1
Jumper Type:
2-pin header
Jumper Settings:
See
513H513H
Table 3-3
Jumper Location:
See
514H514H
Figure 3-8
If the AFL-F08A-N270 fails to boot due to improper BIOS settings, the clear CMOS jumper
clears the CMOS data and resets the system BIOS information. To do this, use the jumper
cap to close the pins for a few seconds then remove the jumper clip.
If the “CMOS Settings Wrong” message is displayed during the boot up process, the fault
may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the
following:
Enter the correct CMOS setting
Load Optimal Defaults
Load Failsafe Defaults.
After having done one of the above, save the changes and exit the CMOS Setup menu.
The clear CMOS jumper settings are shown in
515H515H
Table 3-3
.
- UPC-V312-D525 v1.02
- UPC-V312-D525 v1.10
- UPC-12A_GM45 v1.00
- UPC-12A_GM45 v2.00
- UPC-12A_GM45 v2.10
- UPC-V315-NM70
- UPC-V315-Screw Driver
- UPC-V315-QM77
- S12ASR v1.12
- S12ASR v3.00
- PPC-5xxx-9455 v1.00
- PPC-5xxx-9455 v1.10
- PPC-WIDS-51xxA-G41
- PPC-51xxA-H61
- PPC-5152-D525 v1.02
- PPC-5152-D525 v2.10
- PPC-37xxA-N26 v1.00
- PPC-37xxA-N26 v1.10
- PPC-37xx-N270 v1.01
- PPC-37xx-N270 v2.00
- PPC-37xx-N270 v2.11
- PPC-37xx-N270 v2.20
- ACT-457A
- AFL-4 series-N270 v1.05
- AFL-4 series-N270 v2.10
- AFL-4 series-N270 v2.11
- AFL-4 series-N270 v2.20
- AFL-W19A_W19B_17D_W15A-GM45 v2.10
- AFL-W19A_W19B_17D_W15A-GM45 v1.06
- AFL-W19A_W19B_17D_W15A-GM45 v2.20
- AFL-W15A_17D-GM45 v3.00
- AFL-15i-HM55 v1.01
- AFL-19i-HM55 v2.00
- AFL-15i-HM55 v1.20
- AFL-W19A_W19B_17D_W15A-N270 v1.06
- AFL-W19A_W19B_17D_W15A-N270 v2.20
- AFL-W19A_17D_W15A-N270 v3.00
- AFL-15A_15AE-N270_UMN_v1.01.pdf
- AFL-15A-N270 v1.03
- AFL-15A-N270 v2.10
- AFL-15A-N270 v2.20
- AFL-xxA-N26
- AFL-xxA-N270-Series v1.03
- AFL-xxA-N270-Series v2.00
- AFL-xxA-N270-Series v2.11
- AFL-xxA-N270-Series v2.20
- AFL-xxA-N270-Series v2.30
- AFL-W10A-N270 v1.00
- AFL-W10A-N270 v2.13
- AFL-W10A-N270 v3.10
- AFL-W10A-N270 v3.20
- AFL-08AH-N270
- AFL-07A 08AH 10A 12A-LX Series
- AFL-LX-Series v2.01
- AFL-LX-Series v2.10
- AFL-F08A v1.01
- AFL-F08A v2.21
- AFL-F08A v2.40
- AFL-08B-N270 v1.00
- AFL-08B-N270 v2.10
- AFL-08B-N270 v2.20
- AFL-08B-N270 v2.30
- AFL-057A-LX v1.02
- AFL-057A-LX v2.10
- AFL2-W21-H61
- AFL2-W19A-H61 v1.11
- AFL2-W19A-H61 v1.21
- AFL2-17A-H61 v1.02
- AFL2-17A-H61 v1.11
- AFL2-17A-H61 v1.23
- AFL2-W15B-H61
- AFL2-15A-H61
- AFL2-12A-HM65 v1.00
- AFL2-12A-HM65 v1.12
- AFL2-12A-D525
- AFL2-W15A-N270 v2.00
- AFL2-W15A-N270_W15A-L325 v1.01
- AFL2-W10A-N28
- AFL2-10A-N28
- AFL2-08A-N26
- AFL2-W07A-N26
- POC-17i_19i-Series_IEI
- IBS-19A
- Robot-TP-65M
- RPC-6022G
- RPC-6106_6108
- RPC-6010G
- EC-1040G
- LKM_Series
- IOVU-572M
- IOVU-752S
- IOVU-751R