Operator menus, Changing the setpoint, Selecting status mode – Watlow 8LS Controller User Manual
Page 51: 5sp ? 25, 6 = auto set? tune
Using the 8LS
8LS User’s Guide 43
Operator Menus
You can perform these tasks from Single Loop display.
Changing the Setpoint
Press CHNG SP from the loop you want to change. This display
appears:
•
Press Yes to change the setpoint.
•
Press Yes or No to change the setpoint value.
•
Press Enter to save your changes and return to Single Loop display.
•
Press No or Back to return to Single Loop display without saving the
new setpoint.
Selecting Status Mode
•
Press Man/Auto from the loop you want to change. This display
appears:
•
Press No to switch between Auto, Manual, and Tune.
•
Press Yes and then Enter to store your choice.
•
Press Back if you want to go back to Single Loop display without
changing the mode.
1
2
3
4
5
6
7
8
LOOP
PROCESS
UNITS
ALARM
SETPOINT
STATUS OUTPUT%
5
SP ? 25
1
2
3
4
5
6
7
8
LOOP
PROCESS
UNITS
ALARM
SETPOINT
STATUS OUTPUT%
6 = AUTO
SET? TUNE